29 Mar
2016
29 Mar
'16
5:25 p.m.
On Mar 29, 2016, at 8:18 PM, Guy Sotomayor <ggs at
shiresoft.com> wrote:
I just finished laying out the board for the MEM11A. The last roadblock was figuring out
where the last 3 unrouted wires were. EagleCAD didn?t make it easy to find them and I
haven?t quite figured out how to use the autorouter on Eagle 7.5, so I did this all by
?hand?
(at just under 2000 wires it took a while).
I can imagine. Hand-routing tends to produce much better results; the autorouter in
EagleCAD isn't all that good. A simple way to find the not yet routed wires is to
turn off the metal layers but leave the "ratsnest" layer visible.
paul