29 Jun
2007
29 Jun
'07
10:18 a.m.
On 6/29/07, Bruce Ray <bkr at wildharecomputers.com> wrote:
Before leaving the RX01 topic, note that Chuck's
design was implemented
using the Cadsoft Eagle years ago and is available at:
http://www.wildharecomputers.com/download/rx0x/rx01-b.zip
A minor update is at:
http://www.wildharecomputers.com/download/rx0x/rx01-d.zip
Thanks for those.
The idea of putting an SX-28 processor in control of
the communications and
using a native USB interface resulted in the (untested) derivative design
at:
http://www.wildharecomputers.com/download/rx0x/rx-usb.zip
I'll have to look at that. I have, in hand, an ATMEGA8 bridging USB
to a textual LCD panel for LCDproc / LCD4LINUX, etc. The USB
implementation is in software, keeping the project cost quite low
($3.25 for an ATMEGA8 in low quantities, AFAIK). I might have to see
if I can take what you have there and see if an ATMEGA8 can do it,
too.
I hate the fact that the parallel port is vanishing, but since I can't
keep it from happening, I might as well attempt to keep classic
peripherals working with hardware that's out now and in the near
future.
-ethan