29 Mar
2016
29 Mar
'16
5:51 p.m.
I've never used EagleCAD but some CAD packages let you turn off all routed
lines
On Tue, Mar 29, 2016 at 5:25 PM, Paul Koning <paulkoning at comcast.net> wrote:
On Mar 29, 2016, at 8:18 PM, Guy Sotomayor
<ggs at shiresoft.com> wrote:
I just finished laying out the board for the MEM11A. The last roadblock
was
figuring out
where the last 3 unrouted wires were. EagleCAD
didn?t make it easy to
find them and I
haven?t quite figured out how to use the
autorouter on Eagle 7.5, so I
did this all by ?hand?
(at just under 2000 wires it took a while).
I can imagine. Hand-routing tends to produce much better results; the
autorouter in EagleCAD isn't all that good. A simple way to find the not
yet routed wires is to turn off the metal layers but leave the "ratsnest"
layer visible.
paul