On Sun, May 12, 2013 at 4:44 PM, Lyle Bickley <lbickley at bickleywest.com> wrote:
  I've searched in all the usual spots and
haven't been able to find a
 CMD CQD-240/243 manual. It is a Qbus controller with both single-ended
 and differential SCSI capability. 
http://web.archive.org/web/19961226095644/http://www.cmd.com/ftproot/pub/de…
Taken from CMD CQD-240/243 Manual Revision 2.3
January 1993
Pin Assignments
Physical pin number assignments and functions of the RS-232 port for
accessing the On-Board Utility. Connector J1 pin assignments are
listed in the following table when you are facing the 10 pin connector
 from the controller's top edge. 
NOTE: For
CMD's On-Board RS-232 Utility, only pin 3, 8 and grounds are used.
 ________     ________
|                     |
|    9  7  5  3  1    |
|   10  8  6  4  2    |
|_____________________|
Pin Assignments for Utility/Front Panel Interface
Pin  RS-232 Port                Front Panel Interface
1    No connect                 Reserved; pull up resistors.
2    Ground                     Ground
3    TXD, transmit data         No connect
     for RS-232 application
4    Ground (use pin 2)         Ground
5    No connect                 Activity
6    No connect                 Activity
7    No connect                 Drive 1 write protect,
                                input signal, active low
8    RXD, receive data          Drive 0 write protect,
     for RS-232 application     input signal, active low
9    Ground (use pin 2)         Ground
10   No connect                 Reserved; pull up resistors
NOTE: If W4 and W5 are installed for front panel interface, connector J4 will
be redefined as front panel interface. If you desire Front Panel Write
Protect, you must select it through the On-Board Utility before installing
jumpers. Do not use the RS-232 port when W4 and W5 are installed. To use
RS-232 port, remove W4 and W5. Write Protect default is OFF. W4 and W5
factory setting is OUT.
Host Adapter ID Selections
W10-3  W10-4  W10-5  Initiator ID
IN     IN     IN     Host adapt. ID=7, highest priority (F)
IN     IN     OUT    Host adapter ID=6
IN     OUT    IN     Host adapter ID=5
IN     OUT    OUT    Host adapter ID=4
OUT    IN     IN     Host adapter ID=3
OUT    IN     OUT    Host adapter ID=2
OUT    OUT    IN     Host adapter ID=1
OUT    OUT    OUT    Host adapter ID=0, lowest priority
Note  (F) means factory setting.
CQD-240 Pin Assignments
W1      IN            Differential SCSI terminator power
                      enabled (F)
W1      OUT           Differential SCSI terminator power
                      disabled
W2      1-3 IN        Single-ended channel enabled (F)
W2      2-4 IN        Differential channel enabled
W3      IN            Single-ended SCSI terminator power
                      enabled (F)
W3      OUT           Single-ended SCSI terminator power
                      disabled
W4, W5  1-5 IN, IN    Front Panel Interface enabled
W4, W5  1-5 OUT, OUT  Front Panel Interface disabled (F)
W6      1-2 IN        Reserved
W6      2-3 IN        RS-232 transmit data enabled (F)
W7-1    OUT           9.6 us DMA dwell time
W7-2    IN            4.8 us DMA dwell time (F)
W7-3    OUT           1.2 us DMA dwell time
W7-4    OUT           2.4 us DMA dwell time
W8-1    OUT           Reserved (F)
W8-2    OUT           Reserved (F)
W8-3    OUT           Reserved (F)
W9      1-2 IN        Reserved (F)
W10-1   IN            Tape sync mode disabled
W10-1   OUT           Tape sync mode enabled (F)
W10-2   IN            Disk sync mode disabled
W10-2   OUT           Disk sync mode enabled (F)
W10-6   IN            Enable tape fast search option
W10-6   OUT           Normal operation (F)
W10-7   IN            Tape Monitor Utility enabled (/T, /TM)
                      Disk SCSI format ON-LINE enabled
                      (/M, /TM)
W10-7   OUT           Tape Monitor Utility disabled (F)
                      Disk SCSIformat ON-LINE disabled (F)
W11     OUT           Reserved (F)
W12     OUT           Reserved (F)
W13     1-2 IN        Auto-Bootstrap enabled
W13     2-3 IN        Auto-Bootstrap disabled (F)
W14     IN            Auto-Bootstrap address = 773000 (F)
W14     OUT           Auto-Bootstrap address = 771000
W15     OUT           Reserved (F)
W16     OUT           Reserved (F)
W17     OUT           Reserved (F)
W18     1-2 IN        Block mode DMA enabled (F)
W18     2-3 IN        Block mode DMA disabled
W19     IN            Adaptive DMA enabled (F)
W19     OUT           Adaptive DMA disabled
W20     IN            22-Bit addressing (F)
W20     OUT           18-Bit addressing
W21     1-2 IN        Interrupt level 5
W21     2-3 IN        Interrupt level 4 (F)
W22     1-2 IN        Reserved (F) (Rev. C & D only)
                      27256 EPROM
W23     1-2 IN        Reserved (F) (Rev. C & D only)
                      27256 EPROM
W24     1-2 IN        Reserved (F) (Rev. C & D only)
                      27256 EPROM
W25      OUT          Reserved (F) (Rev. C and D only)
W26      2-3 IN       Reserved (F) (Rev. D only)
Note: (F) means factory setting
CSR Address Selections
The following table lists the 30 disk CSR addresses supported by the CQD-240/M
and CQD-240/TM with the IC P24016B in U101.
CQD-240/M and CQD-240/TM CSR Addresses (Rev D)
Addr  LSI-11    Micro VAX  SW1-1  SW1-2  SW1-3  SW1-4  SW1-5
1     17772150  200001468  ON     ON     ON     ON     ON
2     17760334  200000DC   ON     ON     ON     ON     OFF
3     17760354  200000EC   ON     ON     ON     OFF    ON
4     17760374  200000FC   ON     ON     ON     OFF    OFF
5     17760340  200000E0   ON     ON     OFF    ON     ON
6     17760344  200000E4   ON     ON     OFF    ON     OFF
7     17760350  200000E8   ON     ON     OFF    OFF    ON
8     17760360  200000F0   ON     ON     OFF    OFF    OFF
9     17760364  200000F4   ON     OFF    ON     ON     ON
10    17760370  200000F8   ON     OFF    ON     ON     OFF
11    17760400  20000100   ON     OFF    ON     OFF    ON
12    17760404  20000104   ON     OFF    ON     OFF    OFF
13    17760410  20000108   ON     OFF    OFF    ON     ON
14    17760414  2000010C   ON     OFF    OFF    ON     OFF
15    17760420  20000110   ON     OFF    OFF    OFF    ON
16    17760424  20000114   ON     OFF    OFF    OFF    OFF
17    17760430  20000118   OFF    ON     ON     ON     ON
18    17760434  2000011C   OFF    ON     ON     ON     OFF
19    17760440  20000120   OFF    ON     ON     OFF    ON
20    17760444  20000124   OFF    ON     ON     OFF    OFF
21    17760450  20000128   OFF    ON     OFF    ON     ON
22    17760454  2000012C   OFF    ON     OFF    ON     OFF
23    17760460  20000130   OFF    ON     OFF    OFF    ON
24    17760464  20000134   OFF    ON     OFF    OFF    OFF
25    17760470  20000138   OFF    OFF    ON     ON     ON
26    17760474  2000013C   OFF    OFF    ON     ON     OFF
27    17760500  20000140   OFF    OFF    ON     OFF    ON
28    17760504  20000144   OFF    OFF    ON     OFF    OFF
29    17760510  20000148   OFF    OFF    OFF    ON     ON
30    17760514  2000014C   OFF    OFF    OFF    ON     OFF
31    disable disk         OFF    OFF    OFF    OFF    OFF
The following table lists the tape CSR addresses supported by the CQD-240/T
and the CQD-240/TM with the IC P24017A in U100.
CQD-240/T and CQD-240/TM CSR Address Selections (Rev D)
Addr  LSI-11    MicroVAX  SW1-6  SW1-7  SW1-8  SW1-9  SW1-10
1     17774500  20001940  ON     ON     ON     ON     ON
2     17760404  20000104  ON     ON     ON     ON     OFF
3     17760444  20000124  ON     ON     ON     OFF    ON
4     17760504  20000144  ON     ON     ON     OFF    OFF
5     17760544  20000164  ON     ON     OFF    ON     ON
6     17760410  20000108  ON     ON     OFF    ON     OFF
7     17760450  20000128  ON     ON     OFF    OFF    ON
8     17760454  2000012C  ON     ON     OFF    OFF    OFF
9     17760414  2000010C  ON     OFF    ON     ON     ON
10    17760420  20000110  ON     OFF    ON     ON     OFF
11    17760460  20000130  ON     OFF    ON     OFF    ON
12    17760510  20000148  ON     OFF    ON     OFF    OFF
13    17760514  2000014C  ON     OFF    OFF    ON     ON
14    17760520  20000150  ON     OFF    OFF    ON     OFF
15    17760550  20000168  ON     OFF    OFF    OFF    ON
16    17760554  2000016C  ON     OFF    OFF    OFF    OFF
17    17760560  20000170  OFF    ON     ON     ON     ON
18    17760604  20000184  OFF    ON     ON     ON     OFF
19    17760610  20000188  OFF    ON     ON     OFF    ON
20    17760614  2000018C  OFF    ON     ON     OFF    OFF
21    17760620  20000190  OFF    ON     OFF    ON     ON
22    17760644  200001A4  OFF    ON     OFF    ON     OFF
23    17760650  200001A8  OFF    ON     OFF    OFF    ON
24    17760654  200001AC  OFF    ON     OFF    OFF    OFF
25    17760660  200001B0  OFF    OFF    ON     ON     ON
26    17760704  200001C4  OFF    OFF    ON     ON     OFF
27    17760710  200001C8  OFF    OFF    ON     OFF    ON
28    17760714  200001CC  OFF    OFF    ON     OFF    OFF
29    17760744  200001E4  OFF    OFF    OFF    ON     ON
30    17760750  200001E8  OFF    OFF    OFF    ON     OFF
31    17760754  200001EC  OFF    OFF    OFF    OFF    ON
32    disable tape        OFF    OFF    OFF    OFF    OFF