Circuit board trace repair...

William Sudbrink wh.sudbrink at
Mon Aug 10 16:31:49 CDT 2020

Hi All,


I'm going to be attempting to repair, both cosmetically and operationally, a
circuit board that had a strip of 12 volt trace "blown off" of it by a
short.  The fiberglass is clean and there was no solder resist in the
affected area.  I'm considering using 3M 1183 adhesive tinned foil tape for
the job.  Has anyone else done this?  Could you recommend this or another
product?  Any tips?



Bill Sudbrink


This email has been checked for viruses by Avast antivirus software.

More information about the cctech mailing list